Quantum Scalar i6000, User Manual

Page: 180 / 738

Chapter 3: Configuring Your Library
Setting Up the Network Configuration
162 Quantum Scalar i6000 User’s Guide
Setting Up the Network Configuration
If your library has an MCB2 installed, you can configure two (2) network
settings for your library. When looking at the Setup > Network Settings
menu, you’ll notice two (2) interface options. Depending on what you
have enabled, you’ll see IPv4 or IPv6 listed.
The intended use of these settings is twofold:
• Interface 1 is for configuring a gateway to go outside the network.
• Interface 2 is for accessing devices on it’s own network, encryption
keys and for security. You cannot configure a gateway and cannot
access any devices outside the network. You can access the library
from a browser, however.
Make sure that your library is attached to a network before you use the
Network Configuration command.
Caution: When configuring both interface settings, the IPs must be
on separate subnets. If you configure the second interface
with the same IP, you will not be able to save the
configuration settings.
Caution: You must fully understand all network issues before you
change the network configuration for an already
configured library. It is recommended that you consult with
your network administrator before changing your network
configuration.
Note: To set up an iPv6 network connection, make sure that the IPv6
option is enabled on the Physical Library dialog, as described
in Setting Up Policies for the Physical Library on page 180.
Note: For all site-to-site customer firewall network settings, see
Appendix B, Network Port Settings .
1 Log on as an administrator.