Quantum Quantum ValueLoader, User Manual

Page: 50 / 90

ValueLoader Administration
Configuring the ValueLoader
36 ValueLoader LTO-1/LTO-2 Tape Autoloader User Manual
To access the
Configuration
menu from the Home Screen or main menu,
press the
[+]
or
[-]
button until
Configuration
appears on the top line of the
LCD screen. Press the
[Enter]
button and then
[+]
or
[-]
to access the
available options. Press the
[Enter]
button to execute the displayed menu
option.
Resetting the
ValueLoader
3
This option resets the ValueLoader robotics and the tape drive within the
ValueLoader, forces a new cartridge inventory, and clears any current
error condition.
To access this option, follow these steps:
1 From the Home Screen or main menu, press the
[+]
or
[-]
button until
Configuration
appears on the top line of the LCD screen, and then press
the
[Enter]
button to select.
2 Press the
[+]
or
[-]
button until
Reset
appears on the LCD screen.
3 Press
[Enter]
to reset the ValueLoader.
After initialization, the ValueLoader returns to normal operation and
displays the Home screen.
Changing the
SCSI ID
3
This option changes the SCSI ID of the ValueLoader and/or tape drive.
The ValueLoader occupies two SCSI IDs (target addresses), one for the
tape drive and the other for the ValueLoader robotics.
The default SCSI IDs for the ValueLoader are
6
for the tape drive and
5
for the robotics. You should only need to change the SCSI IDs if there are
other devices on the SCSI bus using the same SCSI ID.
Note: This option is primarily used if the ValueLoader is in an error
state.