Quantum P3000 Series, User Manual

Page: 121 / 146

Appendix C Automatic Drive Cleaning
Reporting of Cleaning Mode
Quantum|ATL P3000 Series User’s Guide 101
GUI
3
To change automatic cleaning mode from the touch screen GUI,
select
Configuration/Auto Clean
:
•
Enable
- turns automatic cleaning mode on
•
Disable
- turns automatic cleaning mode off
Mode Select
Command
3
To change the automatic cleaning mode using the Mode Select
command set the Vendor Unique Page (20h) byte 2, bit 1 (AC) to:
• One - enable automatic cleaning
• Zero - disable automatic cleaning
To save the automatic drive cleaning mode setting in NVRAM set
the Mode Select command Save Page (SP) bit to one.
When the automatic drive cleaning mode setting is saved in
NVRAM, neither a SCSI bus reset or a power cycle of the Product
Name will change the mode setting.
Reporting of Cleaning Mode
3
The current drive cleaning mode can be reported by:
• Diagnostic Software
• Mode Sense command
Diagnostic
Software
3
To display the current drive cleaning mode from diagnostic
software select:
•
Config/Report Clean Tape
The diagnostic screen will display the:
• Current cleaning mode
• Bar code label of each cleaning cartridge