Quantum LTO-9 HH SAS, User Manual

Page: 36 / 120

Chapter 3: Installation
Connect Power
28 Quantum LTO-9 HH SAS User’s Guide
Figure 6 Example of
connecting the SAS device to
two servers
4 Ensure the host adapter and the server are configured correctly for a
SAS bus operation. Refer to the host adapter and server
documentation for instructions.
5 If the power cord has already been installed, turn power to the tape
drive ON.
Connect Power
1 If the power cord has already been installed, skip to step 3.
2 Plug the power cord into the rear panel, then plug the other end
into a grounded electrical outlet.
3 Power-on the unit by pressing the Power button. The POST runs,
which checks all hardware except the drive head. During the POST,
the Single-character Display (SCD) flashes several segmented
1 Tape drive 4 SAS host adapter card
2 SAS connectors 5 Servers
3 SAS cables