Quantum DXi4510, User Manual

Page: 55 / 292

Chapter 3: DXi4000 Remote Management
Accessing Remote Management
Quantum DXi4000 User’s Guide 31
Figure 13 Login Window
If the Login window does not display, verify that the IP address is
correct and that the network path to the DXi4000 is valid. Also
verify that you are using a supported Web browser. Then try again.
If you are still unable to access the Login window, contact your
DXi4000 administrator.
Note: The default IP address is 10.1.1.1 . The IP address can be
changed during installation using the Getting Started
Wizard or at a later time on the Network page (see
Network on page 176).
3
Select the login type and enter the corresponding password.
•
Monitor
- Allowed to view information on the DXi4000 remote
management console but cannot make changes. (The default
password is
password
.)
•
Administrator
- Allowed to view and change information on
the DXi4000 remote management console. (The default
password is
password
.)
Note: Passwords are limited to 15 characters. All alphanumeric
characters are allowed, as well as underscores ( _ ) and
hyphens ( - ). Passwords can be changed on the Web & CLI
Passwords page (see Web & CLI Passwords on page 192).
4 Click Login .