Quantum DXi4510, User Manual

Page: 286 / 292

Appendix B: Troubleshooting
Common Problems and Solutions
262 Quantum DXi4000 User’s Guide
Temperature Problems
Temperature problems are generally caused by incorrect room
temperature, poor air circulation inside the DXi4000 rack or
components, or a malfunctioning cooling fan (see Environmental
Specifications on page 285).
Use the following procedure if a temperature problem is reported:
1 Check the ambient temperature of the room containing the
DXi4000 system to verify that the temperature falls within the
specified range.
2 Inspect for adequate air circulation inside the rack. Some racks may
provide additional fans to improve air circulations. Check the fan for
proper operation. Clean or replace any air filter as necessary.
The replication was
paused and a Failure
event was generated
in the Replication
Events page.
This is normal. When a replication is paused,
a failure event is generated on the
Replication Events page. They system will
continue the replication when you click
Resume .
Replication was
disabled while a
replication was in
process and the
replication
completed.
If you click Disable during a replication in
process, the system will complete the entire
replication and then disable replication on
the system. The system will be unable to
replicate until you click Enable .
Enabled replication
on a NAS share and
received the following
Event:
No
destination host
is specified for
replication.
You must configure the target system prior
to configuring the source. If the target
system is not configured first, you will not
be able to designate the replication target.
Able to enable and
schedule replication
for NAS even though
no target IP
configured.
It is possible to enable and schedule a
replication when a target system has not
been configured. The replication will not
start until a target system is configured.
Problem Explanation/Corrective Action