Quantum DXi4510, User Manual

Page: 180 / 292

Chapter 9: DXi4000 Configuration
Replication
156 Quantum DXi4000 User’s Guide
Figure 88 Replication Send
Page
To specify the replication target:
1 If you have previously specified a replication target, you must pause
the replication service before changing the target.
Replication Service displays the replication status of the DXi4000.
Click Pause to pause replication activity. Click Resume to resume
replication activity.
Note: For a detailed description of all possible replication
statuses, see Replication Overview on page 76.
2 In the Target Hostname or IP Address box, enter the hostname or
IP address of the system that will receive the replicated data.
Note: When entering IP addresses, never use an address that is in
a reserved IP address range. To see a list of reserved IP
address ranges, click the quick tip icon [?] located near the
IP address field.
Note: To use hostname format, you must specify at least one DNS
IP address on the Network page (see Network on
page 176).
3 (Optional) Clear the Use Encryption check box to disable encryption
when sending the snapshot to the destination.