Quantum DXi2500-D, Manual

Page: 14 / 162

Quantum DXi-Series Command Line Interface (CLI) Guide
6-66538-03 Rev C
November 2010
14 VTL Configuration CLI Commands
model = DXi8500
drivemodel = QUANTUMDLTS4
drives = 2
media = 2
slots = 12
serial = 123456XYZ
dedup = enabled
backupwindow = disabled
end
Listing Available Library
Models
syscli --list library
This CLI command allows the CLI admin to display a list of the available library
models. Specific library model or product ID is required when adding or creating
a new partition.
An example output of three supported library models is shown below:
library count = 3
library = 1
productid = DL1500
description = EMC Disk Library
library = 2
productid = Scalar 100
description = ADIC Scalar 100
library = 3
productid = Scalar i2000
description = ADIC Scalar i2000
end
Listing of Supported
Tape Drive
syscli --list drive
This CLI command allows the CLI admin to display a list of the available virtual
tape drive models. A specific virtual tape drive model is required when adding or
creating a new partition.
An example output of two tape drive is shown below:
tapedrive count = 2
tapedrive = 1
model = QUANTUMDLTS4
description = Quantum DLT S4