Quantum Corporation
DLTtape
Application Note
_____________________________________________________________________________________________
Copyright 1999-2001 Quantum Corporation or its subsidiaries or affiliates. All rights reserved
DLTtape Tape Unit Installation IRIX 5.3 and 6.X SGI sytems
This application note is to be used only as a guideline for the titled subject. The user assumes all
responsibility for understanding the interrelationships of this information with other affected software or
system products. Quantum Corporation provides this information as a service only, and assumes no
responsibility for any damages which, could result from the use of this information.
The information in this application note is subject to change without notice and is not to be construed as a
commitment by Quantum Corporation. Quantum Corporation assumes no responsibility for any errors that
may appear in this document.
NOTE:
The information in this document pertains to DLT™ 2000,DLT™ 2000XT, DLT™ 4000, DLT™ 7000
or DLT™ 8000 cartridge tape drive or the DLT™ 2500, DLT™ 2500XT, DLT™ 2700, DLT™ 2700XT,
DLT™ 4500 or DLT™ 4700 tape mini-library that you are installing.
The following section describes the installation and configuration of a DLTtape tape peripheral on the
Silicon Graphics system running IRIX release 5.3 or 6.X. The DLTtape controller firmware must be
OEM-1.
The section following the installation includes information about DLT tape cartridge compatibility and
information about IRIX behavior when there are periods of non-use of the DLTtape drive. The last section
describes important information regarding the use of an installed DLTtape mini-library.
Installation
SGI system must have the appropriate SCSI interface for DLTtape drive to attach to, i.e., a SCSI single-
ended DLTtape drive can be attached only to a SCSI single-ended interface. The same is true for SCSI
differential attachment. The hardware attachment requires the DLTtape tape peripheral to be attached to
the SCSI interface while the system is powered down. After the DLTtape tape peripheral has been
attached, you will need to make file modifications and perform certain system operations that allow the
DLTtape tape peripheral to be recognized.
Perform the installation as follows:
1.
Shut down the SGI system and remove ac power from the system. Install the DLTtape tape peripheral
and connect it to its SCSI controller. Depending on the DLTtape tape peripheral you are installing, refer to
one of the following manuals for switch and jumper settings and SCSI bus termination:
•
DLT2000/DLT2700 product manual (order number 81-109132)
•
DLT2500 owner's manual (order number 81-109374)
•
DLT2000XT/DLT2500XT/DLT2700XT product manual (order number 81-109253)
•
DLT4000/DLT4500/DLT4700 product manual (order number 81-106336)
•
DLT7000 Tape Drive product manual (order number 81-60000)
•
DLT8000 Tape Drive product manual (order number 81-60118)
Set the DLTtape SCSI device address to an unassigned ID.
2.
Turn power on and boot the system. Log on as root and execute the following UNIX command to verify
the DLTtape attachment:
hinv -c tape
