Quantum ATL SuperLoader ATL, User Manual

Page: 97 / 196

Chapter 3 Media Changer Commands
Mode Sense (6) / (10) Command (1Ah/ 5Ah)
Quantum ATL SuperLoader Software Interface Guide 79
Table 34 Mode
Sense Page
Descriptor
TapeAlert Page
(1Ch)
3
LTO only: The SuperLoader supports the TapeAlert Page that is
used to set/change the supported TapeAlert configuration
options. Use the MODE SENSE command to read the settings of
the TapeAlert page.
Figure 44 TapeAlert
Page Format
Descriptor
Field Name Description
PS Parameters Savable. When 0, the supported
parameters cannot be saved (savable pages are not
supported). When set to 1, it indicates that the page
can be saved in nonvolatile memory by the media
changer.
Additional Page
Length
This field indicates the number of bytes in the page.
Note that this value does not include bytes 0 and 1.
The length is returned on MODE SENSE and must
subsequently be set to the same value when
performing MODE SELECT.
Bit
Byte
7 6 5 4 3 2 1 0
0
PS (0) 0 Page Code (1Ch)
1
Additional Page Length (0Ah)
2
Perf Reserved DExcpt Test Rsvd LogErr
3
Reserved MRIE