Quantum ATL M-Series, User Manual

Page: 121 / 222

Chapter 6 Running the Demonstration Programs
Running the Demo 5 Program
ATL M-Series User’s Guide 103
Running the Demo 5 Program
6
The
Demo 5
program causes the robot to pick a randomly selected
cartridge from its magazine slot and place it in another magazine
slot on another level of the stacked library. This test maximizes the
use of the StackLink.
To run the
Demo 5
program:
1
Verify that at least:
• Two library modules are installed in the stack
• One magazine is installed in each library module
• One cartridge is present
2
Access the
Demo Programs
screen (see Accessing the Demo
Programs Screen on page 97).
3
Press the
Up
or
Down
buttons to select
Demo 5
.
4
Press
Select
.
The
Demo 5
program starts. This program continues until you
press the
Stop
button.
5
To stop the program, press
Stop
.
The GUI displays a status screen listing the demonstration
program number, the number of cycles completed, and the
status of the test: pass or fail.
6
Press
Back
to return to the
Demo Programs
screen.
Note:
This program is for multiple library stacks only.