Quantum ATL M-Series, User Manual

Page: 113 / 222

Chapter 5 Running Diagnostic Programs
Running the Display Test
ATL M-Series User’s Guide 95
The test starts and the GUI displays a
Running Diag
screen. The
test stops automatically after completing the selected number
of cycles. When the test is complete, the GUI displays a screen
indicating the test status.
To abort the test before it completes the selected number of
cycles, press
Stop
.
13
Press
Back
.
The GUI displays the cycle count screen.
14
Press
Cancel
, then
Back
to return to the
Diags: General
screen.
Running the Display Test
5
The
Display Test
allows you to verify that the GUI has no missing
pixels and that the two status indicators on the library front panel
work correctly.
To run the
Display Test
:
1
Access the Diagnostics Menu screen (see Accessing the
Diagnostics Menu Screen on page 85).
2
Press the
Up
and
Down
buttons to select
General
.
3
Press
Select
.
The GUI displays the
Diags: General
screen (see figure 48 on
page 87).
4
Press the
Up
and
Down
buttons to select
Display Test
.
5
Press
Select
.
The test starts. The GUI goes dark momentarily, and both of the
status indicators flash. This test lasts approximately three
seconds.