Manual for KD7E/333 series
Jumper Settings
Jumpers are located on the motherboard, they represent, clear CMOS jumper JCC,
enable BIOS ProtectEasy function jumper JAV etc. Pin 1 of all jumpers are located on
the side with a thick white line ( Pin1
→
), refer to the motherboards
silkscreen. Jumpers with three pins will be shown as to represent pin1 & pin2
connected and
to represent pin2 & pin3 connected.
Overclocking Jumper Setting (JFSB)
The jumper JFSB located on the mainboard provides users with CPU overclocking feature.
The host bus speed can be set as 100/133MHz. The table below for your reference.
AMD Athlon CPU FSB is 100MHz/133MHz, but delivering twice the throughput of 100MHz/
133MHz Pentium III-based systems(Ultra -Fast 200MHz/266MHz). However, whether or
not your system can be overclocked depends on your processors capability. We do not
guarantee the overclocking system to be stable.
Warning: Be sure your selection is right. CPU over speed will be dangerous! We will
not be responsible for any damages caused.
Note: It is not used with FSB 133 CPU and FSB 100 DDR together.
Chapter 2
HCLK
JFSB
100MHz
133MHz
Close( default )
Open
JFSB
