Setup checklist
Before using the Cubiscan 110-XT for the first time, verify the following:
•
Have the Cubiscan 110-XT and the computer (if applicable) been placed
in the proper operating environment?
•
Has the Cubiscan been fully assembled?
•
Have the sensor cables been connected to the sensors?
•
Has the back panel been secured?
•
Have the shipping bolts been removed?
•
Has the base of the Cubiscan been leveled?
•
Is the Cubiscan free moving? The Cubiscan should not be pushed up
against a wall and no object, cable, etc., should be resting on it or
against it.
•
Has the AC power adapter been connected correctly?
•
Has the Cubiscan 110-XT been set up to communicate with a computer
(if applicable)?
•
(Optional) Has the barcode scanner been connected properly?
•
If you are using Qbit to operate the Cubiscan 110-XT, has the
application been copied onto your computer’s hard-disk drive? (Refer to
the Qbit User Guide for information.)
•
Does the Cubiscan require recalibration? The Cubiscan 110-XT was
calibrated at the factory, but may require recalibration due to handling
during shipping. Refer to
for information on calibrating the
Cubiscan 110-XT. If you are using Qbit software, check the status of the
Cubiscan before operating it. Refer to the Qbit User Guide for
information on checking the Cubiscan’s status.
