GARAGE DOOR REMOTE CONTROL KIT - MODEL GDRC
The GDRC universal garage door remote control kit consists of a remote controlled receiver switch, power supply and two
transmitters and is designed to add a remote control facility to garage door openers. It
can be used with any garage door
opener that has an existing low voltage wall mounted push button control.
Installation
Before making any connections ensure that power to the garage door opener is switched off
.
1.The receiver should be located in a position near to a mains socket and within 3 metres of the garage door opener push
button control.
2. Locate the wall mounted push button that controls the garage door, remove its cover and connect the 2 core wire from the
receiver to the push button terminals that have wires connected to them, polarity does not matter. Replace the bell push cover.
If the push button has more than 2 wires please telephone us before proceeding.
3.Connect the power adaptor to the receiver and then plug the power adaptor into a mains socket and switch on the power.
4.
The 2 transmitters supplied have been programmed if you do not have additional transmitters go to step 7,
if you
have additional transmitters program them as follows.
5.
Remove the receiver cover by removing the two screws, connect the power adaptor.
6.Push and release the LEARN button, the red LED on the receiver will light, push the transmitter button marked A, the red
LED on the receiver will flash and then turn off. The transmitter is now programmed
(the transmitter button must be pressed
within 3 seconds of pressing the LEARN button)
repeat for button B. Repeat the above for any additional transmitters you
need to program. Replace the receiver cover.
7. Switch on power to the garage door opener and press the transmitter button marked A to test operation.
8.The single white wire is the antenna, do not cut this and for maximum range keep away from mains wiring and metallic
objects
Deleting learnt transmitter codes - Erasing the receiver memory
If you lose a transmitter, you can erase the receiver memory so that the lost transmitter will no longer operate the garage door, after
erasing the receiver memory you will need to re-program the transmitters you wish to use, see step 6 above.
1.To erase the receiver memory, remove the receiver cover.
2.Push the LEARN button for approximately 5 seconds until the red LED on the receiver flashes and then switches off, all the
transmitter codes in the memory have now been erased.
