Quantek FD 10, Mounting And Operating Instructions

Page: 20 / 27

7.2 Configuration
(CONFIG)
Parameter Description Setting range Default
APuGo Triggering angle Push&Go (angle push&go) OFF, 2...10° OFF
ASES 1) Suppression point Safety Element stop.
If Ao is changed, ASES is automatically set to Ao.
45°...Ao 95°
ASER 2) Suppression range of the safety element reversing 0...60° 0°
SeOpCo Persistent opening
After a Safety Element Stop during the opening procedure, the door shall
continue its opening move, as soon as SES is activated
.
OFF
ON OFF
SeOpTi Waiting time till the drive unit closes even if SeOpCo = ON closes,
in the event that a fixed object blocks the doors
(only visible if
SeOpCo = ON)
PERMAN
1...60 s 20 s
SESClo Safety element Stop activated/deactivated during the closing
motion ACTIVE
INACTI INACTI
EMY-IN Configuration of the Emergency terminal (break contact) CL-SPR
(spring)
STOP
OPEN
CL-MOT
(motor)
CL-SPR
OExStp Step-by-step control function OFF
OEI
OEO
KEY
RADIO OFF
RC 0.1 Parametrizable relay output 1 on optional PCB 1
(only visible if relay PCB 0 is plugged in)
CLOSED
OPENING
OPEN
CLOSING
ERROR
PSAUTO
PSNIGHT
PSEXIT
PSOPEN
PSMANU
GONG
LOCKED
SIX30S
EMY_AL CLOSED
RC 0.2 Parametrizable relay output 2 on optional PCB 1
only visible if relay PCB 0 is plugged in)
OPEN
RC 0.3 Parametrizable relay output 3 on optional PCB 1
only visible if relay PCB 0 is plugged in)
ERROR
RC 0.4 Parametrizable relay output 4 on optional PCB 1
only visible if relay PCB 0 is plugged in)
GONG
RC 1.1 Parametrizable relay output 1 on optional PCB 2
(only visible if relay PCB 1 is plugged in)
OPENING
RC 1.2 Parametrizable relay output 2 on optional PCB 2
only visible if relay PCB 1 is plugged in)
CLOSING
RC 1.3 Parametrizable relay output 3 on optional PCB 2
only visible if relay PCB 1 is plugged in)
PSAUTO
RC 1.4 Parametrizable relay output 4 on optional PCB 2
only visible if relay PCB 1 is plugged in)
LOCKED
Unlock Impulse/permanent unlocking IMPULS
PERMAN IMPULS
EL-Fb Return signal of the electric lock
N.O. -> Contact open if in the unlocked state (-), .closed if in the locked state (+)
N.C.
->
Contact open in the locked state (+), closed in the unlocked state (-)
OFF
N.O.
N.C. OFF
LockAU Operating mode AUTOMATIC locked
(only visible if Unlock = Perman)
UNLOCK
LOCK UNLOCK
LockEX Operating mode EXIT locked
(only visible if Unlock = Perman)
UNLOCK
LOCK LOCK
LockMA Operating mode MANUAL locked
(only visible if Unlock = Perman)
UNLOCK
LOCK UNLOCK
LcdDir Orientation of the display 0...1 0
MovCon Endurance test Open/Close OFF
ON-FLT
ON-PRM OFF
OExMAN Acceptance of opening commands after a manual door opening
(only if APuGo = OFF) OFF
ON OFF