6
Commissioning
Warning:
During the setting-up procedure (which must only be carried out by experts),
the safety devices (radar, sensors, ...) are switched off!
Before initiating the setting-up procedure, it is important to make sure that
neither persons nor objects remain within the danger area of the moving
door leaf, in order to avoid injuries or damages!
Procedure:
1.
Switch on the drive unit (Power-up).
2.
Using the joystick, adjust the display direction: Move the joystick
downward once-> the display direction is switched to a readable
position.
3.
Programming the type of rods (Rod):
Move the joystick to the left/to the right.
Validate the correct type of rods by means of OK: In the rest position,
shortly push in the joystick.
4.
Adjust the distance dAxis (distance in cm between the rotation axis
of the door hinges and the mounting level of the drive unit -> see
illustration below).
Note:
dAxis is an approximate value. Depending on the installation
situation, dAxis may have to be adapted.
5.
Adjust the opening angle Ao and validate by means of OK.
Attention:
The steps 4 and 5 are influenced by the installation measures/
distance between the door hinges.
