Quanta Cloud Technology QuantaMesh QNOS5, Configuration Manual

Page: 43 / 256

43
in interface configuration mode.
(QCT) (Interface 0/1)#ip address dhcp client-id
Physical Interface:
To enable DHCP with client-id (option 61) on from on the physical interface, issue the commands as
shown below:
(QCT) #config
(QCT) (Config)#interface 0/4
(QCT) (Interface 0/4)#ip address dhcp client-id
VLAN Interface:
To enable DHCP with client-id (option 61) on from on the VLAN interface, issue the commands as shown
below:
(QCT) #config
(QCT) (Config)#interface vlan 10
(QCT) (Interface vlan 10)#ip address dhcp client-id
2.3. Booting the Switch
When the power is turned on with the local terminal already connected, the switch goes through Power-On
Self- Test (POST). POST runs every time the switch is initialized and checks hardware components to
determine if the switch is fully operational before completely booting.
If a critical problem is detected, the program flow stops. If POST passes successfully, a valid executable image
is loaded into RAM.
POST messages are displayed on the terminal and indicate test success or failure.
To view the text that prints to the screen during the boot process, perform the following steps:
1. Make sure that the serial cable is connected to the terminal.
2. Connect the power supply to the switch.
3. Power on the switch.
As the switch boots, the boot-up test first counts the switch memory availability and then continues to boot.
4. During boot, you can use the Utility menu, if necessary, to run special procedures. To enter the Boot
menu, press 2 within the first five seconds after the following message appears.
Select startup mode. If no selection is made wiithin 3 seconds,
the Quanta OS Application will start automatically...