Quanser QNET 2.0 HVAC Quick Start Manual Download Page 1

Page: 1 / 4

Quick Start Guide:

QNET 2.0 HVAC

To complete your QNET HVAC setup, you will also need the following hardware:

1. Quanser QNET 2.0 HVAC board

2. 24VDC, 2.7A Power Supply

Check Components and Details

STEP 1

Make sure your QNET HVAC experiment includes the following components:

Additional Components Required

Install LabVIEW and Add-Ons

STEP 2

STEP 3

Make sure the following versions of LabVIEW™ and required add-ons are installed:

1. LabVIEW™ 2012 or later
2. NI DAQmx 9.5.5 or later
3. NI ELVISmx 4.4 or later
4. LabVIEW™ Control Design and Simulation Module 2012 or later

Note:

The QNET curriculum resources are

available for download at www.ni.com/qnets

1. NI ELVIS II or NI ELVIS II

workstation

2. +5VDC / 5A, +15VDC / 2A,
-15VDC / 0.8A Power Supply
3. USB Cable

Power Cable for the QNET 2.0 HVAC

  power supply (available through
  National Instrument based on your
  country’s power/voltage requirements)

Note:

All references to NI ELVIS II in

this guide apply to both NI ELVIS II
and NI ELVIS II

devices.

Summary of Contents for QNET 2.0 HVAC

Page 1: ...quired add ons are installed 1 LabVIEW 2012 or later 2 NI DAQmx 9 5 5 or later 3 NI ELVISmx 4 4 or later 4 LabVIEW Control Design and Simulation Module 2012 or later Note The QNET curriculum resources...

Page 2: ...r at the back of the QNET board into the female connector on the NI ELVIS II To set up the QNET HVAC please read the following instructions carefully For full details see the QNET HVAC User Manual Con...

Page 3: ...If not consult the troubleshooting section at the end of this guide Testing the QNET HVAC STEP 5 C H Ensure that the 15V 15V 5V and the External Power LEDs on the QNET board are lit Ensure that LEDs o...

Page 4: ...d on the back panel of the NI ELVIS II unit and the prototyping power switch situated on the top of the NI ELVIS are ON If one or more of the 15V 15V or 5V LEDs is still not lit then the 15V or 5V fus...