Quanser QNET 2.0 DC Motor Quick Start Manual Download Page 1

Page: 1 / 4

Quick Start Guide:

QNET 2.0 DC Motor

To complete your QNET DC Motor setup, you will also need the following hardware:

1. Quanser QNET 2.0 DC Motor board

2. 24VDC, 3.0A Power Supply

Check Components and Details

STEP 1

Make sure your QNET DC Motor experiment includes the following components:

Additional Components Required

Install LabVIEW and Add-Ons

STEP 2

STEP 3

Make sure the following versions of LabVIEW™ and required add-ons are installed:

1. LabVIEW™ 2012 or later
2. NI DAQmx 9.5.5 or later
3. NI ELVISmx 4.4 or later
4. LabVIEW™ Control Design and Simulation Module 2012 or later

Note:

The QNET curriculum resources are

available for download at www.ni.com/qnets

1. NI ELVIS II or NI ELVIS II

workstation

2. +5VDC / 5A, +15VDC / 2A,
-15VDC / 0.8A Power Supply

3. USB Cable

Note:

All references to NI ELVIS II

in this guide apply to both NI
ELVIS II and NI ELVIS II

devices.

Summary of Contents for QNET 2.0 DC Motor

Page 1: ...W and Add Ons STEP 2 STEP 3 3 1 2 1 Make sure the following versions of LabVIEW and required add ons are installed 1 LabVIEW 2012 or later 2 NI DAQmx 9 5 5 or later 3 NI ELVISmx 4 4 or later 4 LabVIEW...

Page 2: ...he back of the QNET board into the female connector on the NI ELVIS II To set up the QNET DC Motor please read the following instructions carefully For full details see the QNET DC Motor User Manual C...

Page 3: ...graphs should resemble those shown here If not consult the troubleshooting section at the end of this guide Testing the QNET DC Motor STEP 5 C H Ensure that the 15V 15V 5V and the External Power LEDs...

Page 4: ...t lit Ensure that the PCI connector on the QNET board is properly connected to the female connector on the NI ELVIS II unit Check that the system power switch located on the back panel of the NI ELVIS...