7.1 Before You Begin
7-2
501801 Rev. 07-01-19
Currently there are two types of SCSI tape drive assemblies available. See
. LTO3 models, which require termination at both ends of the SCSI bus and
LTO4 models, which are self terminating in the tape drive assembly itself.
7.1
Before You Begin
Before installing the tape drive assemblies, create a map of where each tape drive should
go. See
for a worksheet you can use to help plan tape drive
installation.
7.1.1
Guidelines for Tape Drive Installation
When determining where to install the tape drives, consider the following rules and
guidelines:
•
Drive filler assemblies.
For safety and UL compliance, a drive filler assembly
(see
) must be installed in any unused tape drive slot. If there are
empty tape drive slots, the handler will be prevented from moving when power is
applied to the library.
•
Logical libraries.
To simplify logical library definition and maintenance, use
side-by-side locations within a drive bay when installing the tape drives for a
logical library. As required, you can install drive filler assemblies to reserve
specific tape drive locations for future growth. Or, you can install the tape drives
for more than one logical library in a single bay.
•
Tape drive interface.
Although you can install SCSI and Fibre Channel tape
drives in a single bay, you may want to use the lowermost bays for SCSI tape
drives. This will help minimize cable length issues if you connect the HBA and
Figure 7-3
Drive filler assembly
Summary of Contents for XLS-810160
