7
1250W:
For heat function - Press this switch while the 0/I switch is in the ON position.
The indicator light will be ON.
Temperature Control:
To adjust the temperature to your individual requirements, turn
the temperature control dial to the right (clockwise) to increase the desired temperature
and to the left for lower temperature. This temperature control dial can only be used
while the 0/I switch and 1250W switches are in the ON position.
NOTE:
When the O/I switch is turned off, all other heater functions will stop even
though the switches may be in the on position.
MAiNtENANcE
WARNING: Disconnect power and unplug the power cord before attempting any
maintenance or cleaning to reduce the risk of fire, electric shock or damage
to persons. The bulbs in your unit can become extremely hot. Allow at least 10
minutes between turning off the unit and removing the light bulbs to avoid the
accidental burning of the skin.
RIsK OF FIRe: dO NOT exceed The RecOMMeNded BulB wATTAge.
rEPlAciNG tHE liGHt BUlBS
Step 1: Remove 12 screws on the back of fireplace and open the rear cover. There are
2 larger screws and 10 smaller screws.
Step 2: You will find 1 x 40W type B-10 bulb under log-set bed.
Step 3: Loosen and remove the burnt out bulb and replace with new bulb.
Step 4: Close the rear cover. Secure the larger screws into top left corner hole and
bottom right corner holes as shown in the diagram. Secure the 10 smaller
screws into the remaining holes. Make sure the screws are in the correct holes
and have been tightened.
Step 5: Plug in the unit.
rEPAir SEt
tOUcH-UP rEPAir PAiNt
Paint directly on the mantel unit if necessary.
rEPAirS
If any problems are found with the original parts during mantel assembly, such as the
panels cannot be installed with the plastic connector, try to solve by one of the following
methods:
Tools required:
Electric drill, drill bits 3/4 inches (10 mm) or 1/16 inches (2 mm),
pencil, hammer, Phillips screwdriver, safety goggles and gloves (if necessary).
wARNINg: wear goggles before you start drilling.
OPTION 1:
Use the spare KD nuts, KD screws and plastic connector.
1. Place the plastic connector on the mantel unit and mark the drill-holes as shown in
Fig. A.
Fig. A
2. Drill the holes with diameter 3/4 inches (10 mm) and depth 3/4 inches (10 mm) on
the mantel. Each plastic connector needs 3 holes. See Fig. B.
Fig. B
Fig. C
3. Gently install the KD nuts into the drilled-holes with hammer as shown in Fig. C.