20
STB / Remote IR – RF Mode Conversion
For customers who wish to place the STB in a non-line of sight position (with respect
to the remote control) the remote must operate in RF mode. As the remote operates
in IR mode by default the user will have to convert the remote operation from IR mode
to RF mode by the following sequence:
•
While in the same room with the STB, press and hold on the remote for
approximately 3 seconds. The remote LED will initially display red.
•
After 3 seconds the remote LED will turn green. Immediately press the home
button ( ).
•
A 3-digit code will be displayed on the TV screen.
•
Enter the 3-digit code shown on the TV.
•
If successful, “Connected” will be displayed on the TV screen and the remote
now operates via RF mode.
If “Connected” is not displayed, wait 3 minutes, then try the above procedure again.
Once successfully paired (Connected), the STB may be placed in a non-line of sight
location such as behind the TV or in a cabinet.
To return the remote to the line of sight IR mode of operation, perform the following
steps:
•
On the remote press and hold for 3 seconds, until the LED turns green.
•
On the remote Press .
•
Successful completion is signaled by 2 green blinks.
NOTE:
The remote must be in RF Paired (Bluetooth) mode for remote Voice func
-
tionality to work correctly. If the remote at any time fails to pair, or is not functioning
properly, factory reset the remote using the sequence above,
then re-pair remote.
8
9
1
Remote Pairing Operation
KURV 2.0 VOICE REMOTE
Set
Set
8
9
1
Set
Qtv 2020 | Installation Guide
