BATTERY
BATTERY
Figure 4.11
Wall Thermostat Installation
W
R
W
R
Appliance
Figure 4.10
Figure 4.9
1.
Separate the body of the thermostat from the mount
-
ing plate by gently pulling the two pieces apart. See
Figure 4.9.
2.
Use a drill with either a 3/16 drill bit for drywall or a
7/32 drill bit for plaster drill holes.
3. Using a hammer tap in wall anchors.
4. Route the wires through the opening in the base plate,
and hold the base against the wall while aligning up
to the holes. Attach base plate using a Phillips head
screwdriver and two screws
(C2)
.
5.
Connect your thermostat wire to the W and R termi-
nals. See Figure 4.10.
7.
Snap the thermostat to the base plate.
NOTE:
Ensure bare wire ends are held ALL the way into
the terminal block while the screws are being
tightened.
6. There are two
AA ALKALINE ONLY
batteries already
installed into the thermostat; to activate, remove black
plastic tab that is located inside the battery compart
-
ment.
• Remove the outer thermostat wire cover plate and
insert the end of the wire with the spade ends on it
through the hole in the cover plate. See Figure 4.5.
Continue inserting the wire into the fireplace and
through the hole in the inner cover plate. See Figure
4.6.
• Open the lower access panel on the front of the
fireplace. Locate the end of the thermostat wire and
run it in through from the back of the large hole and up
to and attach it to the terminal block. See Figure 4.7.
Wire through
large hole.
Figure 4.7 Thermostat Wire Attached
Figure 4.8 Thermostat wire installed through outer cover plate
•
Reinstall outer thermostat cover plate. See Figure 4.8.
Inner thermostat wire
cover plate
Figure 4.6
Outer thermostat
wire cover plate
24
Quadra-Fire • PIONEER - III • 4182-901 Installation Manual • Rev C • 07/19