25
February 19, 2020
7037-801B
D. Traditional Leg Installation
Installing your traditional legs to your appliance:
1.
Remove leg brackets from inside of firebox
of appliance.
2.
Lay body of appliance on its back on a protective pad
or pallet.
3.
Remove four screws from bottom of appliance
(Figure 25.1)
.
4.
Install leg brackets to bottom of appliance using the
four just removed screws in step 3.
3
4
2
6
9
5
Figure 25.1
Figure 25.2
Figure 25.3
Figure 25.4
Figure 25.5
7. Carefully stand appliance up and place in
desired location.
8.
Thread Allen bolts through nuts until flush
(Figure 25.2)
9.
Slide Allen bolt/nut assemblies into slots of
two of the legs with the nuts on the bottom
(Figure 25.3 and 25.4)
.
CHECK BAFFLE BOARDS & CERAMIC BLANKET!
•
Verify that the baffle boards and ceramic blanket are
in their proper locations.
•
It is important that the baffle boards and ceramic
blanket are correctly installed for proper burn safety.
CAUTION!
NOTE:
There is a right and a left of the leg brackets
(Figure 25.1)
.
5.
Install six screws to the bottom of the leg brackets
(Figure 25.1)
.
6.
Attach legs onto leg brackets and secure with bolts
and washers.
Do NOT tilt the appliance on the cast iron legs.
• Tilting could lead to property damage.
• Lift the appliance upright and place it into position on
the floor protector.
CAUTION
NOTE:
Legs with leveling bolts need to be on opposite
sides of the appliance - one in the front and one
in the back
(Figure 25.1)
10. Use Allen wrench to adjust legs up and down to desired
level
(Figure 25.5)
.
