ASSEMBLY AND INSTALLATION
18
Connecting Power and Feeder Interface Cables
1.
Make sure that the emergency stop switch of the Tabber is in the OFF (depressed) position
and the main power switch is in the OFF position. Make sure that the power switch, on the
optional feeder, is also in the OFF position.
2.
Connect one end of the
Tabber’s power cord [1]
into the rear of the Tabber,
as shown.
3.
Plug the other end of the
power cord into a 115 Volt
AC, 50/60 Hz. Grounded
outlet.
CAUTION
Do not use adapter plugs or extension cords to connect the Tabber or the feeder to the wall
receptacle.
Do not use outlets controlled by wall switches.
Do not use an outlet that shares the same circuit with large electrical machines or appliances.
4.
Connect the appropriate Feeder Interface Cable (See Appendix “Feeder Interface Cables &
Risers”) into the “FEEDER” connector [2], on the back of the Tabber. Connect the other
end(s) of the feeder interface cable to the appropriate receptacle(s) on the Feeder/Printer.
CAUTION!
Be sure you are using the appropriate feeder interface cable with the appropriate
feeder/Tabber/printer or damage may result. See Appendix “Feeder Interface Cables & Risers”
for proper cable selection.
2
1
Summary of Contents for rena T-950
