76
JUN 2020
USER GUIDE
5
OPERATOR INSTRUCTIONS
DS-200iQ / DS-600iQ
REV 00
5.1.10
TURNER BACKSTOP ADJUSTMENT
If the Turner is fitted directly to the Insert Head exit, an adjustable backstop will
be attached.
NOTE:
The backstop is not fitted when the Turner is fitted to an Output Sorter.
1.
To adjust the backstop, first loosen the thumb screw knob.
2. Place an envelope on the track, touching the rollers inside the backstop.
3. Adjust the backstop so that the opposite edge of the envelope lies
approximately 35mm from the datum side-guide on the other side, as shown
in Figure 5.37.
QTL-RND-OPS-00000139-A-00
Figure 5.37 – Adjusting the Turner backstop
4. Re-tighten the thumb screw knob once the desired adjustments have been
made.
5.1.11
INFEED ROLLERS ADJUSTMENT
The infeed rollers can be adjusted to provide drive onto envelopes if there are
problems transferring them to the turner exit.
To adjust the infeed rollers, simply lower one or both rollers as needed, shown in Figure
5.38.
QTL-RND-OPS-00000140-A-00
Figure 5.38 – Adjusting the infeed rollers
Summary of Contents for DS-200iQ
