74
JUN 2020
USER GUIDE
5
OPERATOR INSTRUCTIONS
DS-200iQ / DS-600iQ
REV 00
5.1.6.2
IN-LINE VERSION
1.
To adjust the Output Conveyor rollers, first loosen the thumb screw knobs on
both sides.
2. Adjust the rollers so that the ejecting envelopes contacts the nip (pinch) point
of the rollers at the conveyor surface, and then falls fully onto the surface as
shown in Figure 5.33.
QTL-RND-OPS-00000135-A-00
Figure 5.33 – Adjusting the Output Conveyor rollers
3. Re-tighten the thumb screw knobs once the desired adjustments have been
made.
5.1.7
OUTPUT CONVEYOR BACKREST ADJUSTMENT
When the envelopes reach the end of the conveyor, they will stack up against the
backrest which can be adjusted to suit the required amount of tilt.
1.
To adjust the Output Conveyor backrest, first loosen the thumb screw knobs
on each side.
2.
Adjust the tilt of the backrest to a satisfied angle as shown in Figure 5.34.
QTL-RND-OPS-00000136-A-00
Figure 5.34 – Adjusting the Output Conveyor backrest
3. Re-tighten the thumb screw knobs once the desired adjustments have been
made.
Summary of Contents for DS-200iQ
