69
JUN 2020
USER GUIDE
5
OPERATOR INSTRUCTIONS
DS-200iQ / DS-600iQ
REV 00
5.1.3.6 FLEX FOLDER SEPARATOR ADJUSTMENT
The separator prevents more than one paper/form being fed at a time. The
adjustment wheels for both the 500-Sheet and 1000-Sheet hoppers are located on the
operator side of the Flex Folder.
1.
To access the separator adjustment wheels, first open the Flex Folder
operator side cover as shown in Figure 5.22.
QTL-RND-OPS-00000125-A-00
Figure 5.22 – Opening the Flex Folder operator side cover
2. Turn the adjustment wheels to open or close the gap, use the markers
indicated in Figure 5.23 as a visual aid to help achieve the required setting.
QTL-RND-OPS-00000126-A-00
Figure 5.23 – Adjusting the Flex Folder separator gap
NOTE:
The separator adjustment wheels for both the 500-Sheet and 1000-Sheet
hoppers are identical, however the adjustment wheel for the 1000-Sheet
hopper is orientated vertically.
3. Adjust the separator gap according to the following:
▪
Single Sheets
(up to 100gsm) - The separator roller should just
contact the pad below. Increase the gap slightly if sheets feed
erratically.
▪
Thicker Forms
- Slide a form into the gap and adjust the wheel until
the separator just grips it.
4. Close the Flex Folder operator side cover once the desired adjustments have
been made.
Summary of Contents for DS-200iQ
