quadient DS-200iQ, Manual, Page: 10 / 231

Power Connections Safety Notes
WARNING
• Ensure any isolation or disconnect device, including the mains power supply
remain unobstructed at all times.
• Ensure the mains power cable and its connectors are sound and undamaged.
Should any electrical cable become damaged do not operate the machine, and
ensure any damaged electrical cable is replaced with a correctly certified and
rated replacement by the manufacturer.
• A voltage of 230V may be present inside this machine. The power source can
produce enough voltage and current to be very dangerous.
• This machine is equipped with a three-pronged plug. One of the prongs on the
plug provides a safety grounding (protective earth) feature. Ensure the plug is
always connected to a properly wired three-prong outlet. Do not use a two-prong
adapter without grounding the machine properly.
• The machine must be earthed. Never remove the third prong from the plug. The
safety grounding (protective earth) feature provides extra protection in the event
of an electrical problem.
• The mains power supply is fused on both live and neutral sides. Service personnel
should be aware that a mains voltage can exist even if no lighted neon shows.
Emergency Safety Notes
WARNING
• Opening any cover of the machine will trigger the interlock safety cut-off switch
and stop the machine operation (including all moving parts).
• Should a fault occur with the machine, immediately isolate the machine completely
from the power source, by pressing the toggle switch located at the rear of the
Insert Head to the off position, and unplugging the mains power cable completely
from the electrical power supply.
8
| Page 8 | May-29-2020 11:33 |
1
Safety
Standards
Compliance