52
DS-1200 G4i Operator Manual Issue 4 - Nov 2020
10.1.2 Cleaning rollers
Periodically, all rollers, feed wheels and conveyor belts should be cleaned to remove
impacted residues picked up from processing printed material. Use a clean, lint-free
cloth dampened with water on all rollers, feed wheels and conveyor belts.
Clean the full width and circumference of all visible rollers and feed wheels, using
the location guide below. Most rollers and wheels can be turned round by hand,
though some may be quite stiff.
Feeder Interface
Located in front of the feeder. Clean the four conveyor belts on the upper conveyor,
then raise this upwards to access the four lower belts.
Feeder
Raise the cover at the input end of the feeder conveyor to reveal the feed wheels
- this also applies to the envelope feeder. Clean the conveyor belts using a clean,
lint-free cloth dampened with water.
Hi-Cap or Std-Cap Feeder
Raise the top cover to reveal the feed wheels. Also lift up the inner plate to access
the rollers below.
Collator
Raise the collator cover and clean the full length of the conveyor belts of both upper
and lower conveyors (release the latches and lift up the upper conveyor to access
the lower conveyor). If a barcode/OMR unit is fitted, clean these conveyor belts and
rollers also.
Envelope Opener
Lift up the black handle in front of the envelope feeder and raise to access the
envelope opener conveyor. Clean the conveyor belts and the rollers using a clean,
lint-free cloth dampened with water.
Turnover
Clean the turnover belts and also the large aluminium wheels that they run on.
