qtxsound VH45B User Manual Download Page 1

Operation 

 

With levels turned down, connect a 6.3mm jack lead from the receiver to the P.A. 
system or mixer and extend the antenna vertical to the receiver unit. 

 

On the handheld transmitter, with the POWER switch off, unscrew the battery cover 
and connect a good 9V (PP3) battery to the contacts, taking note that the “+” and “-“ 
connections are correct 

 

With the VOLUME control turned fully down (anticlockwise), connect the DC adapter 
to the receiver unit and then into the mains outlet, making sure that the adapter and 
lead are in good condition. 

 

Switch on the POWER on the handheld transmitter and check that the RF LED is 
illuminated on the receiver. Switch off the MUTE and speak loudly into the 
microphone, checking that the AUDIO PEAK LED on the receiver flashes with the 
loudest sounds 

 

Turn up the level on the P.A. system or mixer and then turn up the VOLUME control 
(clockwise) on the receiver. The microphone should now be heard through the P.A. 
system or mixer 

 

After use, turn down the level on the P.A. system or mixer and then turn down the 
VOLUME on the receiver, MUTE the transmitter and switch off POWER 

 

Disconnect the receiver from the P.A. system and then unplug from the mains 

 

If not used for a long period of time, remove the battery from the transmitter 

Specifications 

Power supply - Receiver 

9-15Vdc (adapter supplied) 200mA 

Power supply - Transmitter 

9Vdc batter (PP3 type, supplied) 

Carrier frequency 

174.5MHz 

Max deviation 

±25kHz 

Dynamic range 

>90dB 

THD 

<0.5% 

Frequency response 

40Hz-15kHz ±3dB 

Audio output 

400mV 

Signal to noise ratio 

>90dB 

Channel rejection 

>80dB 

Receiver sensitivity 

10dBuV  

Max continuous battery life 

10 hours 

Dimensions - Receiver / Transmitter 

150 x 110 x 35mm / 250 x 50mmØ 

Weight - Receiver / Transmitter 

190g / 280g 

 

1622

 

© QTX Sound 2010 

 

VH45B 

Wireless Microphone System 

171.801 

 

USER MANUAL 

 

Reviews: