QSW-6300 Series Switches Hardware Installation and Reference Guide
Installing the Switch
31
3.4. Installing and Removing the Power Supply Module
Wear anti-static gloves before the following operations.
3.4.1. Installing the AC Power Supply Module
Step 1:
Take out a new power supply module and ensure that the input mode and input indicators
of the power supply module meet requirements.
Step 2:
Remove the filler panel. With the panel printed with the power nameplate information as
the upper panel, grab the power supply module handle with one hand and hold the bottom of the
power supply module with the other hand. Straightly and slowly insert the power supply module
into the chassis along the guide rail until it clicks into place.
Figure 3-5 Installing a Power Supply Module
Note:
Insert the power supply module straightly and slowly. Verify that the power supply
module is in the correct orientation.
Insert the power supply module into the chassis gently. If it is difficult to fully insert the
module, pull the module out, align it to the guide rails and slide it into the slot again.
3.4.2. Removing the AC Power Supply Module
Step 1:
Press the latch to pull out the power supply module with one hand. Hold the power
supply module with another hand.
Step 2:
Install a filler panel in the vacant slot and store the removed power supply module into
its package.
Figure 3-6 Removing a Power Supply Module
Note:
Remove the power supply module straightly and slowly.
Install a filler panel in a vacant slot when the power supply module is removed to ensure
the normal ventilation and dissipation and avoid the dust in the chassis.
