Installation Manual
3. Router Installation
33
www.qtech.ru
The port lightning protector is not provided with the router. The user can
purchase it as required.
The port lightning protector aims for the Ethernet port of the
10/100/1000M electrical interface using the RJ-45 connector.
The port lightning protector specifications contain the technical parameters
and the installation and maintenance instruction of the surge protector.
Refer to the specifications carefully in the actual installation.
Avoid the installation direction of the port lightning protector is connected
reversely. The external cable is connected to the IN end and the router
network port is connected to the OUT end.
Avoid the port lightning protector is improperly grounded. When installing
the PE of the surge protector, keep the PE as short as possible to ensure the
well contact with the router ground terminal. After the connection is
finished, use a multimeter to check the connection.
Avoid that the port lightning protector is incompletely installed. When
there is more than one outbound network port of interconnected cable
between the router and other router, install the lightning protector for all
cable outbound network ports.
3.4.
Connect Power Cable
1.3.4.
Installation Preparations
Considering the lightening protection requirement of the router, it is recommended that
the AC power reaches the better lightening protection effect via the external lightening
equipment when bringing in the router.
Before connecting the power cable, check and ensure that the power switch is OFF.
2.3.4.
Connect AC Power Cable
Step 1:
Insert the AC power cable into the socket of the router power.
Step 2:
Insert the AC power cable to the socket providing power for the router.
The AC power cable is connected, as shown in the following figure.
