7
TD-000521-00-A
Front Panel OLED Screens
Design Status
Refer to
Figure 3
• Device
– The name of the Core as defined in Q-SYS
Designer.
• Design
– The name of the currently running design.
• Status
– Indicates health of Core in design:
OK
– Audio, Video and Control (AVC) engine is good.
Compromised
– AVC engine is good, but a redundancy mechanism is active (one LAN down but the other is still up)
or a non-fatal hardware problem exists (fans too slow, temperature higher than expected, etc.)
Fault
– AVC engine is stopped, or hardware is malfunctioning or mis-configured
Missing
– A piece of hardware, defined in the design, has not been discovered. AVC engine is not communicating
with that piece of hardware.
Initializing
– Starting the firmware, configuration update, or design update.
Rot Present
– A virtual component in the design, that is designated as Dynamically Paired, and Not Required, has no
hardware assigned to it.
System Status
Refer to Figure 4.
• Firmware
– A three-section number identifying the major
release, minor release, and maintenance release. For
example, 6.0.0.
• Temp
– The current chassis temperature of the Core.
• Fan Speed
– This number varies with the temperature.
LAN A
Refer to Figure 5.
You can edit this information in the Q-SYS Configurator.
• Static or Wuto
– Displays next to LAN A, indicates if the
Core's IP Address is Static or Automatic.
• IP Wddress
– The IP Address assigned to the Core's LAN
A. LAN A is the primary Q-LAN connection to the Core,
and is required.
• Ret Mask
– The Net Mask assigned to the Core.
• Nateway
– The Gateway assigned to the Core.
LAN B
LAN B is used for redundancy or segregation of various data types on to different networks but is not required for device
operation. The information is displayed in the same format as LAN A.
LAN AUX
LAN AUX is used for remote monitoring, WAN and VOIP connectivity, and is not required. The information is displayed in
the same format as LAN A.
— Figure 3 —
DEVICE:
DESIGN:
STATUS:
DESIGN STATUS
<Device Name>
<Design Name>
<Status>
— Figure 4 —
FIRMWARE:
TEMP:
FAN SPEED:
SYSTEM STATUS
<firmware number>
<temperature in Celsius >
<fan speed in rpm>
— Figure 5 —
IP ADDRESS:
NET MASK:
GATEWAY:
LAN A (STATIC)
<IP Address of the Core 510i>
<Net Mask of the Core 510i>
<Gateway for the Core 510i>
