36
Detaching a Loudspeaker from the Array Frame
1. Support the weight of the loudspeaker. Remove the Array Frame Rigging Pins on both sides.
2. Lower loudspeaker carefully using rear handles. Loudspeaker remains suspended on Front Strikes.
3. Lift loudspeaker off Array Frame Front Hooks to fully detach.
Array Frame
Rigging Pin
— Figure 57 —
Splay Angle Adjustment for Flown Deployment
The splay angles for loudspeakers within an array can be adjusted individually to 1.5°, 6°, and 12°.
NOTE:
See the “Understanding Splay Angles” section for further details.
Decreasing Angle
1. Push Angle Lever on both sides all the way in, until
they make a click sound and stay depressed.
2. Lift loudspeaker weight slightly to release internal pin.
3. Lower loudspeaker down to the next angle position,
until it makes a click sound.
Increasing Angle
1. Push Angle Lever on both sides all the way in, until
they make a click sound and stay depressed.
2. Lift loudspeaker up into the next angle position, until it
makes a click sound.
WARNING!:
Always verify that the Locking
Lever is in the full downward position (red
indicator will not be visible when locked), and
the Angle Lever is in the outward position after
the hardware is connected. If not properly
latched, the loudspeakers could separate or
change angle unexpectedly and cause
physical damage to the loudspeakers, and/or
personal injury.
1.5°
6°
12°
— Figure 58 —
1.5°
6°
— Figure 59 —
1.5°
6°
— Figure 60 —