background image

 HPRi Loudspeaker Accessory User Manual

HPR YOKE 122 

Yoke Bracket

Introduction

This yoke mount is specifically for mounting the QSC HPR 122i loudspeaker to a structural support element (light-
ing or soundstage truss or other load bearing truss, etc.). Additionally, it may be used vertically oriented atop a 
35mm loudspeaker pole mount allowing up- or down-tilt. It is not to be used as a wall mount or other attachment 
to non-load rated structure.

Contents

•Steel Yoke Bracket (1)
•M10 Hex-head Bolts (2)
•Rubber Flat Washers (2)
•Steel Flat Washers (2)
•Steel Lock Washers (2)
•This User Manual

Important Safety Information

Do not use this yoke bracket to attach the HPR 122i to a wall or other architectural element!

Attach the base of this yoke bracket to the load-bearing structure using appropriate load-
rated hardware approved for the application.

WARNING! Before placing, installing, rigging, or suspending any speaker product, inspect all hard-
ware, suspension, cabinets, transducers, brackets and associated equipment for damage. Any 
missing, corroded, deformed or non-load rated component could significantly reduce the strength 
of the installation or placement. Any such condition severely reduces the safety of the installation 
and should be immediately corrected. Use only hardware which is rated for the loading conditions 
of the installation and any possible short-term unexpected overloading. Never exceed the rating of 
the hardware or equipment. 

Consult a licensed, professional engineer when any doubt or questions arise regarding a physical 
equipment installation. Ensure all local, state, and national regulations regarding the installation, 
operation, and safety of this equipment are understood and adhered to.

Attaching the Yoke to the Loudspeaker

The yoke bracket is designed to attach only to the side rigging points on the loudspeaker as shown in Figure 1.

1- To attach the bracket to the loudspeaker enclosure, you 
must first remove the M10 bolts from the enclosure’s side rig-
ging points (6mm hex wrench required).

2- Attach the yoke to the rigging points using the M10 Hex 
Head Bolts included with the bracket. Note the hardware order 
shown in Figure2. Ensure the rubber flat washers are installed 
between the bracket and the loudspeaker enclosure. The steel 
flat and lock washers are to be installed between the bolt and 
the outside bracket surface. The lock washer is the outermost 
washer, located directly under the head of each bolt.

3- Tighten bolts snuggly, just to the point where the yoke is 
held in place but able to rotate. Set desired tilt and tighten the 
two M10 bolts to secure the loudspeaker in place.

*TD-000247-GP*

TD-000247-00 rev.A 
© Copyright 2007 QSC Audio Products, Inc.
QSC® is a registered trademark of QSC Audio Products, Inc.
“QSC” and the QSC logo are registered with the U.S. Patent and Trademark Office

1675 MacArthur Blvd., Costa Mesa, CA, 92626 USA
Main Number (714) 754-6175 Sales & Marketing (714) 957-7100 or toll free (USA only) (800) 854-4079
Customer Service(714) 957-7150 or toll free (USA only) (800) 772-2834

Figure 1- Attach yoke bracket 
to the side rigging points.

Figure 2- Hardware 
installation order. 

Rubber washers

Flat washer

Lock washer

Bolt

 

Reviews: