106 ©
Copyright 2017 QSAN Technology, Inc. All Right Reserved.
INFORMATION:
Point-to-Point (FC-P2P):
Two devices are connected directly by FC
interface. This is the simplest topology with limited connectivity and
supports 4 Gb/s, 8 Gb/s, and 16 Gb/s fibre channel speed.
Loop (FC-AL, Arbitrated Loop):
All devices are connection in loop or ring,
similar to token ring networking. Add or remove any device will affect
activities on the loop. The failure of any device will cause ring broken.
Fibre Channel hub connects multiple devices together and may bypass
the failed ports. A loop may also be made by cabling each port to the next
in a ring. Loop mode supports 4 Gb/s and 8 Gb/s fibre channel speed
only.
CAUTION:
If the link speed and topology are set, the related fibre channel switch and
HBA on host must be set, too. Otherwise, the connection cannot work
properly.
7.4.3.
Configure Fibre Channel Targets
Click
▼
->
Target Configuration
to set multi-target configurations which are accessible by
the host.
Summary of Contents for XCubeSAN XS5224D
