Installing the System Hardware
Figure 3-31
One Server / One HBA / One XCubeSAN / One XCubeDAS / Dual Path
3.9.
Connecting Power Cords and Powering ON the System
Before you power on your XCubeSAN system for the first time, please make sure following
tasks are done:
Check the power cord type. The power cords for the XCubeSAN series will vary
depending on your country/region. If you find the power cords included with your
XCubeSAN system doesn’t match your current country/region, you may need to buy an
adapter for each power cord to connect the power outlet.
Power cord ratings:
。
100 – 127V~ 10A
。
200 – 240 V~ 5A
Install all disk drives in the system so the controllers can identify and configure them at
power-up.
Connect cables that connect the management port and data ports to your network, and
then power cords to the system; finally press the power button once to power on the
XCubeSAN.
XCubeSAN
XCubeDAS
Wake-on-SAS Cable
Wake-on-SAS Cable
Server
