QP-Audio QPM Series, User Manual

Page: 5 / 20

3
1
1
CH.1
2
3
4
7
6
8
9
10
11
5
1
1. MIC Input Jacks
These are balanced XLR microphone input jacks.
2. LINE input Jacks (mono channels)
These are balanced TRS phone jack line inputs. You can connect either balanced or
unbalanced phone plugs to these jacks.
3. INSERT Jacks
These jacks can be used to insert an external signal processing device between the
equalizer and fader of the corresponding mono input channel.
4. TRIM Control
Adjusts the input signal level.
5. EQUALIZER (High/Mid/Low)
6. CLIP Led
7. PAN Control
8. AUX MON Control
Adjusts the level of the signal sent from the channel to de MON
9. FX Control
Adjusts the level of the signal sent from the channel to the FX SEND Buses
10. SOLO Switch
The solo switch is used to route the channel signal to the solo bus (Solo in Place)
or to the PFL bus (Pre Fader Listen). This enables you to listen to a channel signal
without affecting the main output signal. The signal you hear is taken either
before the pan control (PFL/Mono) or after the pan and channel fader (Solo/Stereo)
11. CHANNEL Fader
Adjusts the level of the channel signal. Use these faders to adjust the balance between
the various channels
NOTE: Set the fader sliders for unused channels all the way down to minimize noise.
Func
tion
EN