Qorivva MPC5xxx/SPC5xx Debugger and NEXUS Trace
78
©1989-2021 Lauterbach GmbH
SYStem.CONFIG.state
Display target configuration
Opens the
SYStem.CONFIG.state
window, where you can view and modify most of the target
configuration settings. The configuration settings tell the debugger how to communicate with the chip on
the target board and how to access the on-chip debug and trace facilities in order to accomplish the
debugger’s operations.
Alternatively, you can modify the target configuration settings via the
with the
commands. Note that the command line provides
additional
SYStem.CONFIG
commands for settings that are
not
included in the
SYStem.CONFIG.state
window.
Format:
SYStem.CONFIG.state
[
/
<tab>
]
<
tab
>:
DebugPort
|
Jtag
|
XCP
<tab>
Opens the
SYStem.CONFIG.state
window on the specified tab. For tab
descriptions, see below.
DebugPort
Lets you configure the electrical properties of the debug connection, such
as the communication protocol or the used pinout.
Jtag
Informs the debugger about the position of the Test Access Ports (TAP) in
the JTAG chain which the debugger needs to talk to in order to access the
debug and trace facilities on the chip.
XCP
Lets you configure the XCP connection to your target.
For descriptions of the commands on the
XCP
tab, see
