Qorivva MPC5xxx/SPC5xx Debugger and NEXUS Trace
15
©1989-2021 Lauterbach GmbH
ESD Protection Considerations
Demo and Start-up Scripts
In your TRACE32 installation directory, there is a subdirectory ~~/
demo/powerpc/
where you will find
example scripts and demo software.
For getting started there is a start-up script for every available PowerPC processor.
1.
In TRACE32, choose
File
menu >
Run Script
.
2.
Navigate to ~~/
demo/powerpc/hardware/
and select your board and CPU. The demo scripts
can be started through the menu
MPC5XXX
>
Tools
>
Start Demo
:
WARNING:
To prevent debugger and target from damage it is recommended to connect or
disconnect the debug cable only while the target power is OFF.
Recommendation for the software start:
1.
Disconnect the debug cable from the target while the target power is
off.
2.
Connect the host system, the TRACE32 hardware and the debug
cable.
3.
Power ON the TRACE32 hardware.
4.
Start the TRACE32 software to load the debugger firmware.
5.
Connect the debug cable to the target.
6.
Switch the target power ON.
7.
Configure your debugger e.g. via a start-up script.
Power down:
1.
Switch off the target power.
2.
Disconnect the debug cable from the target.
3.
Close the TRACE32 software.
4.
Power OFF the TRACE32 hardware.
