Qorivva MPC5xxx/SPC5xx Debugger and NEXUS Trace
10
©1989-2021 Lauterbach GmbH
Parallel Off-chip Trace (parallel NEXUS)
The parallel NEXUS trace port can be used with a PowerTrace/Ethernet or PowerTrace II module and one of
the following NEXUS adapters:
•
LA-7630 NEXUS AutoFocus adapter:
up to 16 MDOs, I/O Voltage 1.0-5.2V, Trace clock up to 200 MHz SDR (up to 100 MHz in DDR)
Debug port sharing support, ext. Watchdog control, cJTAG support
•
LA-7610 NEXUS Adapter MPC55XX:
up to 12 MDOs, I/O Voltage 2.6-3.6V, Trace clock up to 120 MHz SDR.
Debug port sharing support, ext. Watchdog control
•
LA-7612 NEXUS Adapter MPC5510:
up to 8 MDOs, I/O Voltage 3V or 5V, Trace clock up to 110 MHz SDR.
Basic Setup for Parallel Nexus
for more information.
Co-Processor Debugging (eTPU/GTM/SPT)
Debugging the MPC5XXX coprocessors eTPU/eTPU2, GTM and SPT is included free of charge, i.e. there
is no additional license required.
For details about coprocessor debugging, see the specific Processor Architecture Manuals:
•
•
Multicore Debugging
Lauterbach offers multicore debugging and tracing solutions, which can be done in two different setups:
Symmetric Multiprocessing (SMP) and Asymmetric Multiprocessing (AMP). For details see chapter
.
Concurrent debugging of multiple e200 cores requires a
License for Multicore Debugging (MULTICORE)
.
Software-only Debugging (HostMCI) via XCP
TRACE32 PowerView also supports debugging and tracing without using TRACE32 PowerTools hardware.
The debug accesses are done via a 3rd party XCP slave. The following licenses are required to unlock this
feature:
•
LA-8892L: 1 User Floating License PPC Front-End
•
LA-9012L: 1 User Floating License XCP MPC5xxx Debug Back-End
•
LA-8902L: 1 User Floating License Multicore Debugging (optional)
•
LA-9013L: 1 User Floating License XCP MPC5xxx Trace License (optional)
