Plug in power supply
and secure with
retaining screw
IQ PANEL QUICK INSTALL GUIDE
IQ Panel
WARNING: DO NOT CONNECT TO A RECEPTACLE CONTROLLED BY A SWITCH OR HIGH VOLTAGE
GOT QUESTIONS?
CONTACT TECH SUPPORT
?
INCLUDED IN BOX
Remove retainer screw
from panel top
Step 1
Pull back plate off
gently
Step 2
Mount back plate to
wall
Step 3
Hook panel stabilizer
strap onto back plate
Step 4
Connect wires.
DCIN+ to Positive
DCIN- to Negative
Step 5
Connect battery
NEVER DISCONNECT
AFTER INSTALLATION
Step 6
Tilt panel upward onto
back plate until it snaps
in place
Step 7
Replace retainer screw
and tighten
Step 8
Step 9
Connect power supply
Positive to +
Negative to -
Step 10
INST
ALL
HARD
W
ARE
PAIR SENSORS & DEVICES
CONNE
CT
WIFI
SUPPORT
Insert SD Card in slot on
back.
Settings
(default passcode is 1111)
Installation
Security
Sensors
Z-Wave
Devices
Add
Device
AutoLearn
Sensor
“Tamper” Sensor
by opening case
Touch “Pair”
Repeat this process with
each additional sensor
Settings
System Settings
Select the desired network.
Enter Wi-Fi password if required.
ADD USERS
PHO
TO
FRAM
E
Settings
User
Management
Apps
Photo
Frame
Type Name
Type User Code
Select user type
Touch “Load from SD Card”
Replace all or add to library
Test Photo Frame
FOR MORE DETAILED INSTRUCTIONS REFER TO THE IQ PANEL
INSTALLATION MANUAL ON
DEALERS.QOLSYS.COM
Document#: IQPANEL-QG-10-13
Revision Date: 11/4/13
Qolsys Part #: QS-9004-VRZ
Disconnecting the battery may
result in data corruption, panel
failure, and a void of warranty.
CAUTION
BEF
ORE Y
OU
BE
GIN
Press “Learn” button
on device
Security Signaling Residential Fire Alarm and Security Equipment
ETL Listed
Conforms to ANSI/UL Standards
12v Power Supply
IMPORTANT:
ONLY USE
PROVIDED
POWER
SUPPLY
!
!
DO NOT
DISCONNECT
BATTERY
Conforms to ANSI/UL Std. S985. 1023. & 1635
Certified to ULC Sub. C1023 & ULC Std. S545
Qolsys Inc. proprietary. Reproduction without permission is not permitted.
Qolsys Inc.
QS-9004-VRZ
OK
Make adjustments
as needed
Touch Add
Settings
Installation
Make adjustments
as needed
Touch Pair
Repeat this process with
each additional device
NOTE
: If the device does
not learn in you may need
to “Delete Device” first.
See installation manual
for detailed steps
NOTE
: Image Sensors are placed in
“pairing mode” by removing and
replacing the batteries or pressing
the button inside the hole on the
front of the sensor.
Photos must be less than 1MB in size
and saved in “DCIM” or “Photos” folder
Edit photo frame settings
Photo Frame App
Adding
Z-Wave Devices
Adding Security
or Image Sensors
