Qnergy PowerGen 5650 Series, Installation & Operation Manual, Page: 169 / 194

P
OWER
G
EN
R
EPORTS AND
C
HECKLISTS
157
19.3 COMMISSION SEQUENCE
Table 19-4 Commissioning Checklist
Step # Step Initials
1 Connect 12VDC Battery in PowerGen
• Connect ring terminal on black wire to the black terminal on the
battery
2 Disconnect customer electrical load
3 Engine Helium Fill (See “Helium Fill” on page 76)
• Connect laptop to FPC via CAN bus cable, use TC1 temperature
reading for Helium Fill)
• Use “Target Charging Pressure” on page 82 for reference or the label
on the engine beam of the system near the helium fill port
Engine Temperature indicated by FPC: °C
Engine Helium pressure after filling: PSI/BAR
4 Gas type connected to PowerGen: NG LGP Biogas
Gas static pressure (FPC/Data Tap/Gas Pressure): mbar
5 Commissioning FPC firmware version (update to
latest):
6 Commissioning QEC firmware version (updated to
latest):
7 Gas Valve Tuning (See “Gas Valve Tuning, PowerGen 5650” on page 83 or
“Gas Valve Tuning, PowerGen 600, 1200, 1800 (Low Temp systems
included)” on page 89):
• 5650 Lambda High Reading (1.18):
• 5650 Lambda Low Reading (1.23):
• 600/1200/1800 Lambda High reading (1.2):
8 GHT VFD Speed Pot Setting as per PowerGen Feature Set Manual,
7045-102-103-000 (if GHT option is installed):
Customer GHT Tube Length: ft
VFD Speed Setting: