5.
Connect the power cord to the PSU and the electrical outlet.
6.
Power on the NAS.
7.
Enable alerts for PSU failures.
a.
Log on to QTS as administrator.
b.
Go to
Control Panel
>
System
>
Hardware
>
General
.
c.
Select
Enable Redundant Power Supply Mode
.
d.
Click
Apply All
.
Installing Expansion Cards
The NAS supports selected expansion cards, some of which require QNAP PCIe brackets. QNAP-branded
expansion cards purchased from the company website are shipped with the brackets necessary to fit all
QNAP NAS models.
Warning
• Only qualified personnel should perform the following steps. Failure to follow
instructions can result in serious injury or death.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
1.
Check the expansion cards and brackets supported by your model on the QNAP website.
a.
Go to
.
b.
Click
Search by NAS
.
c.
Specify the number of bays and the specific model of your NAS.
d.
Under
Category
, select the component or device type.
TS-x83XU User Guide
Installation and Configuration
22
