2. Install a host bus adapter on the PCIe slot.
Important
The QNAP QXP host bus adapter is required for connecting the SATA JBOD enclosure to a host
device. Third-party host bus adapters are not compatible with QNAP JBOD enclosures.
.
3. Connect the expansion units to the NAS using the following topology.
Note
This image shows connecting the NAS to the TL-R1200S-RP JBOD enclosure.
4. Power on the SATA JBOD expansion units.
5. Power on the NAS.
6. Verify that the expansion units are recognized by the NAS.
a. Log on to QTS as administrator.
b. Go to Main Menu > Storage & Snapshots > Overview > System .
c. Verify that the expansion units are listed.
Installing Handles
Installing handles enables you to better grip and further secure the NAS on a rack. Handles on the TS-464eU
require manual installation.
1. Power off the NAS.
2. Install a handle on an angle bracket.
a. Align the openings on the handle with the two round screw holes on the angle bracket.
b. Attach the screws to lock the handle to the angle bracket.
TS-x64eU User Guide
Installation and Configuration
36
