3. Installation and Configuration
This chapter provides specific hardware and firmware installation and configuration steps.
Hardware installation
This section provides information on installing drives and expansion units.
Drive installation
The NAS is compatible with M.2 solid-state drives and E1.S solid-state drives with heights of up to 15 mm.
Installing M.2 solid-state drives
For a list of compatible M.2 SSDs, go to
https://www.qnap.com/compatibility
Warning
• Installing a drive deletes all data on the drive.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
1. Remove the front cover.
a. Locate the locking mechanism on the right side of the device.
b. Slide the lock down to release the front cover.
c. Slide the front cover latch forward.
d. Pull the front cover away from the device.
TBS-h574TX User Guide
Installation and Configuration
11
