Setting
User Action
Permission
Select one of the following:
• Allow
• Deny
5. Click Save.
QSS adds the IP address–based ACL rule.
Adding a MAC address–based ACL rule
1. Log in to QSS.
2. Go to Configuration > ACL > By MAC Address .
3. Click Add.
The Add ACL - MAC Address window opens.
4. Configure the ACL settings.
Setting
User Action
ACL No.
Specify a number between 1 and 255.
Source
MAC address
Specify the source MAC address.
Destination
MAC address
Specify the destination MAC address.
Port
Select specific ports to apply the ACL rule, or select All to apply the rule
to all ports.
Permission
Select one of the following:
• Allow
• Deny
5. Click Save.
QSS adds the MAC address–based ACL rule.
Configuring QoS settings
Quality of service (QoS) enables the switch to examine incoming packets and classify them into groups to
prioritize certain traffic over others. You can classify these packets based on the type of traffic, source, or
destination address. QSS allows you to configure and enable traffic policies on the switch ports using two
QoS classification techniques, Differentiated Services Code Point (DSCP) and class of service (CoS).
1. Log in to QSS.
2. Go to Configuration > QoS > QoS .
3. Identify a port or LAG.
4.
Under DSCP, click
.
DSCP is enabled on the switch port.
QSW Managed Switches User Guide
QSS
24