2. Product Overview
This chapter provides basic information about the QNAP device.
About the QGD-3014-16PT
The QGD-3014-16PT is a QNAP smart-edge network switch specially designed for surveillance applications.
The switch features built-in storage capacity that can house four 3.5-inch SATA hard drives, software-defined
networking (SDN) to support multiple SMB applications, including NAS, NVR, router, surveillance, and virtual
machines. The QGD-3014-16PT features 16-port 30-watt Gigabit power over Ethernet (PoE) and two
2.5GbE host management ports for fast data transfer. The switch's dual-CPU design offers Layer 2
management functions for VM and QTS applications.
Hardware Specifications
Warning
If your QNAP product has hardware defects, return the product to QNAP or a QNAP-
authorized service center for maintenance or replacement. Any attempt to repair or
perform maintenance procedures on the product by you or an unauthorized third-party
invalidates the warranty.
QNAP is not responsible for any damage or data loss caused by unauthorized
modifications and installation of unsupported third-party applications.
For details, see the
QNAP Warranty Terms and Conditions
.
Tip
Model specifications are subject to change without prior notice. To see the latest
specifications, go to
.
Ordering P/N
CPU
Memory
Power supply
QGD-3014-16PT-8G
Intel Celeron ® J4125
8 GB
Single
Component
QGD-3014-16PT-8G
Processor
CPU
Intel Celeron ® J4125
Frequency
4-core/4-thread 2.0 GHz base/ 2.7 GHz burst
Architecture
x86 64-bit
Encryption engine
AES-NI
Graphics
Intel® HD Graphics 600
Memory
Pre-installed memory
8 GB RAM: 2 x 4 GB DDR4 SODIMM
Memory slots
2 x DDR4 SODIMM
Note
Use only QNAP memory modules to maintain system
performance and stability. For devices with more than
one memory slot, use QNAP modules with identical
specifications.
Using unsupported modules may degrade performance,
cause errors, or prevent the operating system from
starting.
QGD-3014-16PT User Guide
Product Overview
4
